1946 PA 12 180hp Certified. . TTAF 1516, rebuilt new in 2012- 74 hrs on New engine prop Everything new only original parts are fuselage and spars-including all purchased STC's and documentation. All logs complete. Annual Nov. 2016. 180 HP New factory Lycoming engine with Dan's Aircraft STC. New Borer prop. Gross wt increase, flaps, Kenmore left door. Dakota long range tanks, extended baggage, modern dash, sky light, Atlee Dodge extended gear and more. Hangared Airglass penetration skis LW2500 and EDO 2000 available. Detailed equipment attached photos sent on request.Reasonable Offers
TTAF- 1516 hrs
TT since new rebuild 2012 – 74 hrs
TTE-New Lycoming -74 hrs
TT new prop 74 hrs
Airframe gross weight increase to 1935 #.as per STC-SA190AL
Extended baggage compartment as per STC-SA149AL.
Installation of left hand door as per Kenmore Air Harbour STC SA161WE
Installed modified landing gear PA-18 type as per STC SA550AL and SA 148AL.
Modification of elevator control system by installation of certain provisions of PA-18 elevator systemas per STC SA564
Atlee Dodge float fittings weld on as per STC SA00132SE
Structure cleaned, epoxy primed and finished with 2 coats of grey polyurethane.
New aluminum stringers installed.
New floor boards fitted. AC grade
Metal belly installed with rivnuts
Install new approved pullies, cables and all associated hardware.
New aluminum fuel lines/approved fittings installed.
New electrical harness installed complete.
Both wings fitted with new leading and trailing edges; new Dakota Cub flaps installed (DC12768 & DC 12768-1) covered (STC-SA4503NM) and installed as per STC SA578AL.
Install new Whelen 7111001&7111002 14-V wing-tip positional/strobe lights with new wiring
harness, tail position strobe
Complete airframe recovered with ceconite and finished to standard practice – finish coat white
butyrate and blue trim.
New Aero windshield LP-456uVSG
Replaced the Scott Master Brake Cylinder (non-vented diaphram type) with Steve's Aircraft Model
SA6-01 Master cylinder with a vented reservoir as per STC SA01516SE.
New wheel and brake kit from Alaskan Bushwheel P/N 199-62A as per ABI-62A-4 rev A installed in 2015
Install new Scott tail wheel assembly and associated control cables
Both wings completely dismantled. Spars inspected, cleaned, and epoxy primed. Wings reassembled
with new approved fittings and hardware as below.
NewR.H. And L.H. New Dakota Cub replacement wing ribs installed as per STC SA98CH
New 24 gallon Dakota wing tanks installed and inspected as per STC 02171AK. New aluminum fuel
lines, fitting installed. New fuel ram air caps installed Wag-Aero
Installed new R.H. And L.H. Dakota Cub wing ailerons and flaps as per STC SA02191AK and STC SA4503NM, STC SA578Al (primed and covered with ceconite 102 as perSTC SA4503NM) and new push rods, hangers, bell cranks and hardware installed as per STC SA578Al. Wings were installed with new jury strut hardware (Univaire ), new sealed Piper Struts (AD complied), new Piper lift strut forks (Univaire )
Installed new Atlee Dodge stabilizers (2) and elevators (2) as per STC SA 02267AK. Prepared and covered as per STC SA4503NM.
Install complete new trim jack screw mechanism (Univaire )
Installed vortex generators on leading edge of wings and underside of horizontal stabilizers in
accordance with STC SA00530SE
New metal interior and approved upholstery installed.
New TS0 shoulder harnesses (Cubcrafters) installed
New Lycoming engine 0-360 A1A purchased from Lycoming and installed as per STC SA02267AK.
B&C oil filter adapter kit installed to allow rear clearance between oil cooler and firewall. (Aircraft
New stainless steel firewall installed.
New engine mount installed as per STC SA02267AK (Univaire )
New fuel gascolator Steves Aircraft installed as per STC SA01026SE
New 0-360 HH Sutton exhaust system installed STC SE2390CE
New Sky-Tech 149-NL starter, installed STC SE2390CE
New full baffle kit w 180 hp and rear mount oil cooler installed- Airforms AK
New fixed pitch propeller IA200/FA8242, SNL AAG46015 as per STC SA02267Ak. Cubcrafters
New 64336-A HD Spinner180HP-Cubcrafter
New 406 Mhz AMERI-KING AK-451 ELT installed
Airglass skis P/N LW2500 installed as per STC SA02090AK.
New Three-inch extended PA-18 type main landing gear P/N 3284, together with P/N 3164-4 extended shock strut assemblies installed as per STC SA02188AK from Atlee Dodge.
New safety cable kit for new 3-inch extended gear P/N 3344A installed STC SA02190AK from Atlee Dodge.
New brakes lines fabricated as per AC 43.13-1B.
New long step P/N 3195, STC SA02007AK installed on both gear from Atlee Dodge.
New lift rings installed P/N 3217 from Atlee Dodge. New tires 8-00x6 6 ply with new tubes installed to respect Airglass LW2500 ski installation manual.
Burl’s aircraft wheel penetration tail ski installed on Scott 3200 tail wheel.
New magnetos P/N LS03-01010 and alternator filter P/N LS03-01004 installed on engine for radio noise cancellation
New TSO'd instruments
GPS--GARMIN AERA 500 AMERICAS with AIRGIZMO DOCKING
RC ALLEN RCA2600-3 DIG ATT GYR
RC ALLEN 2600 INCLINOMETER
UNITED ASI 40-200 MPH ONLY
UNITED ALTIMETER INCHES 20K
UNITED 3-1/8 VSI 0-2000 FPM
NAVIGATOR TSO COMPASS
EI UBG-16-4 + 8 probes
EI Fuel Flow FP-5L-90
EI VA-1A Volt/Amp
EI SC-5 Super Clock
EI R-1-4 Digital Tach
EI OPT-1 Oil PSI/Temp
Becker ATC 4401-1 Transponder
Becker AR 4201 VHF Transceiver
Aircraft hangared but only on EDO 2000 summer of 2016
Tanis Heater 2014
EZ heat 2014
Tell the dealer you saw this ad on AircraftDealer.com